Operation and Maintenance manual is the must item for all mechanical equipment users, which can ensure all mechanical equipment including diesel engine, transmission, gearbox, axles or even complete trucks under proper on time maintenance, this can extremely extend the using life time of all machines.
Here at EMAC, we continuously collecting all operation and maintenance documents from all brands including Caterpillar, Cummins, Deutz, Perkins, MTU, Weichai, Yuchai, CAMC diesel engines, Fast transmission, Dongfeng Dana axles, Komman Suspensions, Advance transfer case, Advance gearbox etc. and sharing to all partners and customers from all over the world. Video tutorials is also under planning, our continuously hard working is just wanting to help more and more customers to lower down their costs by extending the durability of products.
Operation and Maintenance
Common Problems and Solutions in The Use of Lubricating Oil
What kind of lubricating oil is used for automobile engines is clearly required in the Cummins engine technical manual and should be selected according to the requirements. However, in practice, you may not be able to buy suitable oil. In this case, lubricating oil w...
Fast Transmission Gas Circuit Failure Where Should I Start Checking?
Inspection of pneumatic system failures(1) The inspection of the gas system should be carried out when the engine is turned off and the vehicle air pressure is the maximum nominal value.(2) Check whether each trachea is installed correctly and whether there is any cr...
Analysis of Oil Leakage Failure of Fast Hydraulic Retarder
Share some oil leakage faults of Fast FHB400 hydraulic retarder.1. Oil leakage at the muffler part of the working chamber.The function of the working cavity muffler is that when the retarder is opened, the oil enters the working cavity, the gas in the working cavity ...
How to distinguish between Fast and large 8-speed gearboxes?
It mainly depends on the size of the center distance.The center distance of the gearbox is the distance between the two middle points of a group of gear pairs that are relatively meshed. The larger the center distance, the greater the torque bearing capacity of the g...
Fast Transmission Noise and Vibration Problems
There is a rattling sound when starting the plate shift lever 1. Fork wear 2. The gear is affected by the shaft distortion and leaves the opposite tooth position 3. The intermediate shaft brake does not work 4. Link movement disorder5. Improper adjustment of connecti...
What’s the Matter With the Transmission Overheating?
The transmission will generate a certain amount of heat due to the friction of the moving parts. Normal operating temperature is approximately 38°C above ambient temperature. Heat is dissipated through the transmission housing. If the heat dissipation is not normal...
Contact EMAC Now!